Tuesday, June 21, 2016

Air Conditioner Doesn’t Cool

A window or room air conditioner that doesn’t cool may need to be recharged with refrigerant, but the chances are good it simply needs to be cleaned. You can do this yourself, which involves disassembling the unit, or you can call an air-conditioning professional. Before attempting the work yourself, consult your owner’s manual and make sure you have the right skills and tools to handle the task. Here is what a typical manual advises:
1Unplug the unit and carefully remove it from the window or wall. Put the air conditioner somewhere outdoors or in the garage where you can work on it.
2Remove the grille and filter and unscrew the metal case (taking care not to damage the coil’s fins).

3Wash the filter thoroughly or replace it with a new filter; most filters are readily available at most appliance stores.
4Using a vacuum with a soft brush attachment, clean the coil’s fins.
5Spray water back through the fins from the fan side (protect the wiring and the motor with plastic).
6Clean the unit up with a rag, making sure all drains that allow condensed water to drip away from the unit are open. Allow it to dry thoroughly.
7Lubrication. While you have the unit apart, lubricate the motor according to your owner’s manual.
8Finally, reassemble and reinstall the unit.

Air Conditioner Doesn’t Turn On

Window and room air conditioners draw a lot of electrical power, which can lead to less than peak performance or even complete failure. If your room air conditioner doesn’t turn on:Turn the circuit breaker all of the way off, then flip it back to “ON.”
1Be sure the unit is plugged in and turned on.
2Check that the outlet works by plugging in a light that works (only for standard-voltage models—do not plug a light into a 220/240- volt receptacle).
3If the light doesn’t go on, the circuit has probably overloaded—check the electric panel or fuse box and reset the breaker or replace the fuse.
4If the light works, it’s likely that the air conditioner’s switch is faulty or the thermostat needs adjustment or repair.
5Be sure the thermostat is set to “cool” and below room temperature.

6Refer to the owner’s manual for thermostat repair. If repairing the thermostat doesn’t solve the problem, unplug the unit and call an air conditioner repair person.
in Ras Al  Khaima UAE    

Mobile: 00971556311876

Monday, June 20, 2016

Thermostat

The thermostat is located behind the control panel. Here's how to test and/or replace the thermostat:
Step 1: Remove grille and control panel from unit. Thermostat has special sensing bulb attached to it; this part extends from thermostat into evaporator coil area. Its role is to sense temperature, which is controlled by thermostat.
Step 2: Remove thermostat carefully because you must return sensing bulb to identical spot later. To make replacement easier, tag location of bulb before you remove thermostat.

Step 3: Check thermostat with VOM set to RX1 scale. Clip probes of tester to thermostat terminals, and turn temperature control dial to coldest setting. If meter reads zero, thermostat is functioning properly. If reading is higher than zero, replace thermostat with new one of same type. If thermostat is held to control panel or frame with screws, clips, or metal tabs, connect new thermostat the same way the old one was connected.
Note: If the thermostat has more than two lead wires connected to it (not counting the sensing bulb wire) do not try to test or replace it. Instead, call a professional service person
In Ras Al  Khaima UAE    

Mobile: 00971556311876

Monday, March 17, 2014

Saturday, March 8, 2014



How to Replace an Air Conditioner Fan

 Motor





How to Check the Freon in AC Units


HOME TIPS For 

AC problem


The best time to service an air conditioner is before it's actually needed.
Regular maintenance and cleaning are extremely important.